wphase:documentation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
wphase:documentation [2014/03/19 01:01] wphase |
wphase:documentation [2014/03/19 01:05] wphase |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ===== W-phase documentation ===== | + | ====== W-phase documentation ====== |
| - | ==== Installation ==== | + | ===== Installation ===== |
| To install the code, we must first setup a few environment variables. If you use csh or tcsh: | To install the code, we must first setup a few environment variables. If you use csh or tcsh: | ||
| Line 37: | Line 37: | ||
| ----- | ----- | ||
| + | |||
| + | ===== How to run the W-phase code ===== | ||
| ==== Preparing directories, i_master and CMTSOLUTION ==== | ==== Preparing directories, i_master and CMTSOLUTION ==== | ||
| Line 157: | Line 159: | ||
| - | ==== Notes on file formats ==== | + | ===== Data formats ===== |
| === CMTSOLUTION FILE === | === CMTSOLUTION FILE === | ||
wphase/documentation.txt · Last modified: 2022/01/10 07:39 by wphase
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
