This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wphase:documentation [2014/03/19 01:01] wphase |
wphase:documentation [2014/03/19 01:30] wphase |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== W-phase documentation ===== | + | ====== W-phase documentation ====== |
- | ==== Installation ==== | + | ===== Installation ===== |
+ | |||
+ | ==== Dependencies ==== | ||
+ | |||
+ | The w-phase package have only been tested on Unix and Linux computers. You will need the following: | ||
+ | - csh shell | ||
+ | - gcc and gfortran | ||
+ | - python2.7 | ||
+ | - You have to install pylab and basemap (matplotlib toolkit) to run some python scripts which make figures. | ||
+ | - GMT4 | ||
+ | |||
+ | ==== Building the code ==== | ||
To install the code, we must first setup a few environment variables. If you use csh or tcsh: | To install the code, we must first setup a few environment variables. If you use csh or tcsh: | ||
Line 37: | Line 48: | ||
----- | ----- | ||
+ | |||
+ | ===== How to run the W-phase code ===== | ||
==== Preparing directories, i_master and CMTSOLUTION ==== | ==== Preparing directories, i_master and CMTSOLUTION ==== | ||
Line 157: | Line 170: | ||
- | ==== Notes on file formats ==== | + | ===== Data formats ===== |
=== CMTSOLUTION FILE === | === CMTSOLUTION FILE === |