wphase:documentation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
wphase:documentation [2015/01/23 19:38] wphase [Getting the code] |
wphase:documentation [2015/01/27 17:40] wphase [Dependencies] |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| - csh shell | - csh shell | ||
| - gcc and gfortran | - gcc and gfortran | ||
| - | - python2.7 | + | - python2.7 (or later) |
| - You have to install numpy, matplotlib and basemap to run some python scripts which make figures. | - You have to install numpy, matplotlib and basemap to run some python scripts which make figures. | ||
| + | - rdseed | ||
| - GMT4 | - GMT4 | ||
| To install these dependencies on MacOs, you can refer to [[wphase:macos|this page]]. | To install these dependencies on MacOs, you can refer to [[wphase:macos|this page]]. | ||
| - | |||
| ==== Building the code ==== | ==== Building the code ==== | ||
| Line 72: | Line 72: | ||
| ===== How to run W-phase ===== | ===== How to run W-phase ===== | ||
| - | You should have a look to [[wphase:tutorial|this tutorial page]]. | + | You should also have a look to [[wphase:tutorial|the W-phase tutorial page]]. |
| ==== Preparing directories, i_master and CMTSOLUTION ==== | ==== Preparing directories, i_master and CMTSOLUTION ==== | ||
| Line 194: | Line 194: | ||
| ===== Data formats ===== | ===== Data formats ===== | ||
| + | |||
| + | You can also have a look to [[wphase:tutorial|the W-phase tutorial page]]. | ||
| === CMTSOLUTION FILE === | === CMTSOLUTION FILE === | ||
wphase/documentation.txt · Last modified: 2022/01/10 07:39 by wphase
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
