wphase:documentation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
wphase:documentation [2015/01/27 17:49] wphase [Getting the code] |
wphase:documentation [2015/05/01 10:35] wphase [Dependencies] |
||
|---|---|---|---|
| Line 27: | Line 27: | ||
| - gcc and gfortran | - gcc and gfortran | ||
| - python2.7 (or later) | - python2.7 (or later) | ||
| - | - You have to install numpy, matplotlib and basemap to run some python scripts which make figures. | + | - You have to install numpy, matplotlib, basemap and netCDF4 to run some python scripts which make figures. |
| - rdseed | - rdseed | ||
| - GMT4 | - GMT4 | ||
| - | To install these dependencies on MacOs, you can refer to [[wphase:macos|this page]]. | + | To install these dependencies on MacOs, [[wphase:macos|you can refer to this page]]. |
| ==== Building the code ==== | ==== Building the code ==== | ||
wphase/documentation.txt · Last modified: 2022/01/10 07:39 by wphase
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
