This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wphase:documentation [2018/03/26 16:52] wphase [Building the code] |
wphase:documentation [2018/05/03 16:56] wphase [RUNA scripts] |
||
---|---|---|---|
Line 123: | Line 123: | ||
$WPHASE_HOME/bin/wpinversion -ifil o_wpinv.th1.3 -ofil o_wpinv.th0.9 -th 0.9 | $WPHASE_HOME/bin/wpinversion -ifil o_wpinv.th1.3 -ofil o_wpinv.th0.9 -th 0.9 | ||
</code> | </code> | ||
- | - Finally, it is possible to remove the channels showing a large rms ratios (observed/predicted and predicted/observed) using the option –nr (e.g. –nr 2.0): <code> | + | - Finally, it is possible to remove the channels showing a large rms amplitude ratios (observed/predicted and predicted/observed) using the option –nr (e.g. –nr 2.0): <code> |
$WPHASE_HOME/bin/wpinversion -ifil o_wpinv.th0.9 -ofil o_wpinv.th1.3 -nr 2.0 | $WPHASE_HOME/bin/wpinversion -ifil o_wpinv.th0.9 -ofil o_wpinv.th1.3 -nr 2.0 | ||
</code> | </code> | ||
Line 145: | Line 145: | ||
will perform median and rms misfit screening for Z channels only. | will perform median and rms misfit screening for Z channels only. | ||
- | These two scripts don’t perform the “ratio screening” (i.e. 3. above). To run the same routines with an additional screening based on the ratio (observed/predicted and predicted/observed), the following scripts can be used: | + | These two scripts don’t perform the “ratio screening” (i.e. 3. above). To run the same routines with an additional screening based on the rms amplitude ratio (observed/predicted and predicted/observed), the following script can be used: |
<code> | <code> | ||
${WPHASE_HOME}/bin/RUNA3r.csh | ${WPHASE_HOME}/bin/RUNA3r.csh |